How to Turn 2 Lampshades Into a Chic Modern Pendant

Here's What You’ll Need:

• Wire snippers
• Scissors
• Glue gun and glue sticks
• Ribbon
• Pendant kit (mine had a 4-foot cord)
• A large white paper coolie shade with European hardware (4" x 8" x 6.6")
• A small white paper coolie shade with clip hardware (3.5" x 5" x 5")
• 3 cup hooks (not pictured)

Step 1: Snip

Using your wires snippers, clip hardware off the top of the smaller shade. Try to trim the wires as close to the shade as possible.

Step 3: Glue

Next, run a bead of glue on the outside seam where the two shades meet. This will help hold the shades together.

Step 4: Cover

The ribbon is just the thing to cover the glue seam. To attach the ribbon, I placed a small dot of glue on the end of the ribbon and affixed it to the shade. Next, I wrapped the ribbon tightly around the shade and trimmed it to length. For a clean edge I folded the cut end of the ribbon under and then glued it in place.

Tip: Use an elastic ribbon; the stretch helps it lie flat around the curves and angles of the shade.

Step 5: Finish

To finish the pendant, thread the prewired socket through the center of the shade. The pendant socket should be slightly larger than the central ring of the shade so that it will stay in place. To hard-wire the light in place it's best to hire a pro. I chose to hang three pendants, but one would look great in a smaller space. Once that's done, you can create a cool draped look with the cords using small hooks attached to the ceiling.

Pendant resource: Color Cord / Shade resource: Just Shades